The function of the most powerful crusher in the s

2022-07-27
  • Detail

The function of the strong crusher in the sand production line

the first is the startup of the strong crusher: the strong crusher starts without load, and there is no material in the crushing chamber; Before startup, check whether all components are normal and worn to ensure that all equipment will not affect the operation efficiency; Before starting, check the flexibility of each automatic control device. The latter is an automatic alarm device. If there is any abnormal condition, stop the machine immediately. Before stopping the machine, clean the materials in the crushing chamber, find out the cause and eliminate the abnormal condition before starting again

secondly, the strong crusher often stops suddenly during operation. In this case, the staff must immediately turn off the switch to avoid burning out the motor. Therefore, when the strong crusher is used to crush the materials, it is necessary to first pay attention to the uniformity of the materials and the hardness of the materials

for example, jaw type strong crusher is a variety of strong crushers, which must be replaced immediately after the instigator gives an alarm; Among the crushers, the more representative strong crusher belongs to the coarse crusher. Within a certain range, increasing the number of revolutions of the eccentric shaft can improve the production capacity of the strong crusher, but it will also increase the power consumption of crushing ore per unit weight. If the rotating speed is too high, the crushed ore in the crushing chamber will not be discharged in time, resulting in blockage. On the contrary, in terms of key strategic materials, the production capacity will be reduced and the power consumption will be increased. Therefore, the jaw crusher should have the most appropriate rotating speed. Moreover, in real life, the size of ore discharge outlet is adjusted according to the requirements of ore discharge granularity. Therefore, it is reasonable to enlarge the ore discharge outlet as much as possible under the requirement of ensuring the product particle size. The size of ore outlet can be adjusted by adjusting the block. When adjusting the size of ore outlet, pay attention to the relationship between crushing ratio and productivity. (end)

Copyright © 2011 JIN SHI